Step by step
Installation Guide
Follow these steps for proper Andy Clip™ installation. Always defer to your envelope consultant or engineer when specifications differ.
Level the Window
Ensure the window sill is level and plumb. Prepare the window opening as specified by the manufacturer or envelope consultant.
Install the Clips
Install clips no less than 3" and no more than 10" in each direction from every corner, and every 8"-16" depending on the size of the window. (follows AAMA 2400-02 fasteners specifications)
Apply Caulking
Apply a 3/8" bead of caulk around the entire perimeter of the window and across the back of the window clip. Using glass suction cups, set the bottom of the window in the frame opening and pull the sides and head into the opening.
Nail the Clips
Drive a nail or screw through each clip at an angle away from the window or door.
Evenly Space the Window
Using a pry bar, ensure the window is evenly spaced within the window frame, that the window is level and plumb, and that the "reveal" is even. Shim the sides to eliminate movement.
Near the latch
Near the latch, install at least one 6d nail or screw through a pre-punched hole in the nail flange.
Add Adhesive to the Sides
Apply a 6" to 9" self-sealing adhesive to the WINDOW SIDES, ensuring that the entire window clip is covered, i.e. that no part of clip is showing.
Add Adhesive to the Header
Apply a 6" to 9" self-sealing adhesive to the WINDOW HEAD, ensuring that the entire window clip is covered, i.e. that no part of clip is showing.
Important Notice
Any and all of these steps may be superseded by envelope consultant and or engineer.